Honeywell Xenon 1910 - Page 209

12 - 11
Relink Time-Out Relink Time-Out BT_RLT 3-25
Host Command Acknowledgment Host ACK On HSTACK1 3-27
*Host ACK Off HSTACK0 3-27
Input/Output Selections
Power Up Beeper Power Up Beeper Off - Scanner BEPPWR0 4-1
*Power Up Beeper On - Scanner BEPPWR1 4-1
Power Up Beeper Off - Cordless
Base
BASPWR0 4-1
Power Up Beeper On - Cordless
Base
BASPWR1 4-1
Beep on BEL Character Beep on BEL On BELBEP1 4-1
*Beep on BEL Off BELBEP0 4-1
Trigger Click On BEPTRG1 4-2
*Off BEPTRG0 4-2
Beeper - Good Read Off BEPBEP0 4-2
*On BEPBEP1 4-2
Beeper Volume - Good Read Off BEPLVL0 4-2
*Low (Default-Xenon HC) BEPLVL1 4-2
Medium BEPLVL2 4-2
*High BEPLVL3 4-2
Beeper Pitch - Good Read
(Frequency)
Low (1600) (min 400Hz) BEPFQ11600 4-3
*Medium - Xenon (2700 Hz) BEPFQ12700 4-3
*Medium - Granit (3200 Hz) BEPFQ13200 4-3
High (4200) (max 9000Hz) BEPFQ14200 4-3
Vibrate - Good Read Vibrate - Good Read Off TFBGRD0 4-3
*Vibrate - Good Read On TFBGRD1 4-3
Vibrate Duration Duration
(100 - 2,000 ms) *300
TFBDUR#### 4-3
Beeper Pitch - Error (Frequency) *Razz (250) (min 200Hz) BEPFQ2800 4-4
Medium (3250) BEPFQ23250 4-4
High (4200) (max 9000Hz) BEPFQ24200 4-4
Beeper Duration - Good Read *Normal Beep BEPBIP0 4-4
Short Beep BEPBIP1 4-4
LED - Good Read Off BEPLED0 4-4
*On BEPLED1 4-4
Number of Beeps - Error *1 BEPERR3 4-5
Range 1 - 9 BEPERR# 4-5
Number of Beeps - Good Read *1 BEPRPT1 4-5
Range 1 - 9 BEPRPT# 4-5
Beeper Volume Max Beeper Volume Max PAPBLM 4-5
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric entry
Page