Honeywell Xenon 1910 - Page 214

12 - 16
Intermessage Delay Range 0 - 1000 (5ms increments) DLYMSG## 6-4
Data Formatter Selections
Data Format Editor *Default Data Format (None) DFMDF3 7-1
Enter Data Format DFMBK3## 7-2
Clear One Data Format DFMCL3 7-2
Clear All Data Formats DFMCA3 7-2
Data Formatter Data Formatter Off DFM_EN0 7-12
*Data Formatter On,
Not Required,
Keep Prefix/Suffix
DFM_EN1 7-12
Data Format Required,
Keep Prefix/Suffix
DFM_EN2 7-12
Data Formatter On,
Not Required,
Drop Prefix/Suffix
DFM_EN3 7-12
Data Format Required,
Drop Prefix/Suffix
DFM_EN4 7-12
Data Format Non-Match Error Tone *Data Format Non-Match Error
Tone On
DFMDEC0 7-13
Data Format Non-Match Error
Tone Off
DFMDEC1 7-13
Primary/Alternate Data Formats Primary Data Format ALTFNM0 7-13
Data Format 1 ALTFNM1 7-13
Data Format 2 ALTFNM2 7-13
Data Format 3 ALTFNM3 7-13
Single Scan Data Format Change Single Scan-Primary
Data Format
VSAF_0 7-14
Single Scan-Data Format 1 VSAF_1 7-14
Single Scan-Data Format 2 VSAF_2 7-14
Single Scan-Data Format 3 VSAF_3 7-14
Symbologies
All Symbologies All Symbologies Off ALLENA0 8-1
All Symbologies On ALLENA1 8-1
Codabar Default All Codabar
Settings
CBRDFT 8-2
Off CBRENA0 8-2
*On CBRENA1 8-2
Codabar Start/Stop Char. *Don’t Transmit CBRSSX0 8-2
Transmit CBRSSX1 8-2
Codabar Check Char. *No Check Char. CBRCK20 8-2
Validate, But Don’t Transmit CBRCK21 8-2
Validate, and Transmit CBRCK22 8-2
Codabar Concatenation *Off CBRCCT0 8-3
On CBRCCT1 8-3
Require CBRCCT2 8-3
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric entry
Page