p.50
Place the base of the steering unit securely on the mounting surface, ensuring the clamp is in place.
3
4
Rotate the clamp shaft clockwise while holding the steering wheel unit to secure in place.
１
Insert the suction cups into the 4 holes on the
base od the steering unit. Turn each one 90
degrees anticlockwise to secure them.
２
Stick to the indicated line.
Uneven
Fragile (i.e., glass)
Breathable material Dust / Dirt
Thin or soft
Steering Unit - Suction Cups
Flat, hard surface required (i.e., table)
8 / 20
To Next Page
Loading...
