Horizon Hobby E-FLITE Conscendo Evolution - Battery Selection; Battery Installation; Center of Gravity (CG); Transmitter and Receiver Binding; Enabling and Disabling SAFE Select

Battery Selection
We recommend the Spektrum 2200mAh 14.8V 4S 30C Li-Po (SPMXB22004S30).
If using another battery, the battery must be at least a 1200mAh 3S or 4S battery.
Be sure to verify the center of gravity is correct with your selected battery before flying.
Battery Installation
1. Lower the throttle and throttle trim to the lowest settings.
2. Power on the Transmitter, then wait 5 seconds.
3. Push the button on top of the fuselage, behind the hatch and remove the battery hatch.
4. Remove the battery hatch and install the battery all the way to the front of the battery compartment. See the
Adjusting the Center of Gravity instructions for more information.
5. Make sure the flight battery is secured using the hook and loop strap.
6. Connect the battery to the ESC and keep the aircraft immobile on the ground and away from wind for 5
seconds.
⇒ The ESC will sound a series of tones (refer to step 5 of the binding instructions for more information).
If the ESC sounds a continuous double beep after the flight battery is connected, recharge or replace the
battery.
7. Reinstall the battery hatch. Push the rear of the battery hatch securely to ensure the latch is fully engaged.
Center of Gravity (CG)
An aircraft with correct CG has its weight balanced on the center of the aircraft for safe, stable flight.
Balance the aircraft on your fingertips near the fuselage under the wings. Adjust the battery position as needed.
If the nose goes down, move the flight battery back until the aircraft balances.
If the nose goes up, move the flight battery forward until the aircraft balances.
Transmitter and Receiver Binding / Enabling and Disabling SAFE Select
General Binding Tips
The included receiver has been specifically programmed for operation of this aircraft. Refer to the receiver
manual for correct setup if the receiver is replaced.
Keep away from large metal objects while binding.
Do not point the transmitter’s antenna directly at the receiver while binding.
The orange LED on the receiver will flash rapidly when the receiver enters bind mode.
• Once bound, the receiver will retain its bind settings for that transmitter until you re-bind.