If the receiver loses transmitter communication, the failsafe will activate.
Failsafe moves the throttle channel to low throttle. Pitch and roll channels move to actively level the aircraft in
flight.
If problems occur, refer to the troubleshooting guide or if needed, contact the appropriate Horizon Product
Support office.
SAFE® Select Technology, Optional Flight Envelope Protection
The BNF Basic version of this airplane includes SAFE Select technology, enabling you to choose the level of flight
protection. SAFE mode includes angle limits and automatic self leveling. AS3X mode provides the pilot with a direct
response to the control sticks. SAFE Select is enabled or disabled during the bind process.
With SAFE Select disabled the aircraft is always in AS3X mode. With SAFE Select enabled the aircraft will be in
SAFE Select mode all the time, or you can assign a switch to toggle between SAFE Select and AS3X modes.
Thanks to SAFE Select technology, this aircraft can be configured for full-time SAFE mode, full-time AS3X mode, or
mode selection can be assigned to a switch.
IMPORTANT: Before binding, read the transmitter setup section in this manual and complete the transmitter setup
table to ensure your transmitter is properly programmed for this aircraft.
IMPORTANT: Move the transmitter flight controls (rudder, elevators, and ailerons) and the throttle trim to neutral.
Move the throttle to low before and during binding.
This process defines the failsafe settings.
You can use either the bind button on the receiver case or the conventional bind plug to complete the binding and
SAFE Select process.
Using the Bind Button:
To Next Page
Loading...
