8. Bind the aircraft to your transmitter.
9. Make sure all linkages move freely.
10. Perform the control direction test with the transmitter.
11. Perform the AS3X reaction test with the aircraft
12. Adjust the flight controls and transmitter as needed.
13. Perform a radio system range test.
14. Find a safe open area to fly.
15. Plan flight for flying field conditions.
Transmitter Setup (BNF)
IMPORTANT: After you set up your model, always rebind the transmitter and receiver to set the desired failsafe
positions.
If your transmitter allows it, enable the throttle cut feature. Always engage throttle cut before approaching the aircraft.
Dual Rates
Low rate is recommended for the initial flights.
NOTICE: To ensure AS3X® technology functions properly, do not lower rate values below 50%. If lower rates are
desired, manually adjust the position of the pushrods on the servo arm.
NOTICE: If oscillation occurs at high speed, refer to the Troubleshooting Guide for more information.
Expo
After first flights, you may adjust expo in your transmitter.
Some of the terminology and function locations used in the iX12 programming may be slightly different than other
Spektrum AirWare™ radios. The names given in paranthesis correspond to the iX12 programming terminology.
Consult your transmitter manual for specific information about programming your transmitter.
Model Assembly
Installing the Tail
1. Slide the horizontal stabilizer tube into the hole in the rear of the fuselage.
2. Install the 2 piece (left and right) horizontal stabilizer as shown. Ensure the control horn faces down.
To Next Page
Loading...
