Hoshizaki MODULAR CUBELET SERENITY SERIES FS-1022MLH-C User Manual

35
6)Makesurethe"GM"LEDison.Thereisadelayofatleast30secondsbeforethe"GM"
LEDturnsonafterpower-up.Afterthe"GM"LEDturnson,pressthe"SERVICE"button
located on CB to bypass the 5-minute ice purge cycle. WARNING! Risk of electric
shock. Care should be taken not to touch live terminals. The"COMP"LEDturns
on.
7) Press the actuator paddle located in the top of the chute.
S1 dip switch 7 in the "ON" position: Comp and GM de-energizes within 10 seconds
and CB sounds a 9-beep alarm. S1 dip switch 7 in the "OFF" position: Comp and
GM de-energize within 10 seconds. Diagnosis: If MBC does not open or the icemaker
continues to make ice, check that the actuator paddle is moving freely. Conrm that the
actuator paddle is engaged. Check for continuity across MBC wires. If MBC contacts
are found open and the icemaker continues to make ice, CB is bad and must be
replaced. If MBC is closed with the actuator paddle engaged, MBC is bad and must be
replaced.
8)Movethepowerswitchtothe"OFF"position,thenunplugtheunitfromtheelectrical
outlet.
9) Replace the chute assembly and strap in their correct positions.
10) Replace the control box cover and top panel in their correct positions.
11) Plug the unit into the electrical outlet.
12)Movethepowerswitchtothe"ON"positiontostarttheautomaticicemakingprocess.
13) Replace the front panel in its correct position.
Legend: CB–control board; Comp–compressor; GM–gear motor; IS–infrared sensor;
MBC–mechanical backup bin control

Hoshizaki MODULAR CUBELET SERENITY SERIES FS-1022MLH-C Specifications

General

Brand	Hoshizaki
Model	MODULAR CUBELET SERENITY SERIES FS-1022MLH-C
Category	Ice Maker
Language	English