Hotpoint RB731 - The Problem Solver

To saveTime and rvIoney——
before you
I’eqwst service,
Cheekthe Pmbkm solver
~}IE~ WILL. NOT WORK
OVEN LIGHT
DOES NOT WORK
FOOD DOES NOT
BROIL PROPERLY
-A=%%
WW-’
FOOD DOES NOT ROAST
OR BAKE PROPERLY
CALROD@SURFACE UNITS
NOT FUNCTIONING
PROPERLY
OVEN WILL NOT
SELF-CLEAN
OVEPJDOOR
WONT LATCH
If you havea problem, it may be
Solverto locate your problem and
minor. You may be able to correct
then
followthe suggested
it yourself,Just use this Problem
recommendations,
POSSIBLE CAUSE AND REMEDY
7
Plug on range isnot completelyinserted in the outlet receptacle,
I
The circuit breaker in your house has been tripped, or a fuse has
been blown.
Oven controls are not properly set.
Door left in locked position after cleaning.
Light bulb is loose.
Bulb is defective.Replace.
Switch operating oven light is broken. Call for service.
OVEN SET Knob not set at BROIL.
OVEN TEMP Knob not set at BROIL.
Door not left ajar as recommended.
Improper shelfposition is being used
Necessarypreheating was not done,
Food is being cooked on hot pan.
Utensilsare not suited for broiling.
Check BroilingChart.
Aluminum foil used on the broil pan rack has not been fitted properly
and slit as recommended.
OVEN SET Knob not set on BAKE.
OVEN TEMP Knob not set correctly.
Shelf position is incorrect. Check Roasting or Baking Charts.
Oven shelf is not level.
Wrong cookware isbeing used. When roasting, pan is too small.
A foil tent was not used when needed to slow down browning during
roasting.
Surface units are not plugged in solidly.
Trim rings/drip pans are not set securely in the range top.
Surface unit controls are not properly set.
4utomatic timer dial/dials not set or not set properly. The STOP dial
nust be set and advanced beyond the time noted on oven clock.
Ile STOP dial was not advanced for long enough.
3oth OVEN SET and OVEN TEMP Knobs must be set at CLEAN
;etting.
4 thick pile of spiliover when cleaned leaves a heavy layer of ash in
pots which could have insulated the area from further heat.
.atch not in “CLEAN” position.
‘urn OVEN SET Knob to CLEAN. Glowing Locked Light after knob
s turned iildicates oven is too hot from previous useand door won’t
Itch, l-o cool oven, open door wide, then latch can be moved.
)VEN SET Knob must be at CLEAN or OFF before Latch can be
loved.
.atch Release Button not pushed when moving Latch.
23