HP 10500 series - Page 48

For more information about OSPFv3, see Layer 3—IP Routing Configuration Guide.
To configure OSPFv3 between IPv6 MCE and VPN site:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an OSPFv3 process for
a VPN instance and enter
OSPFv3 view.
ospfv3 [ process-id ] vpn-instance
vpn-instance-name
Perform this configuration on the
IPv6 MCE. On a VPN site,
configure normal OSPFv3.
3. Set the router ID.
router-id router-id N/A
4. Redistribute remote site routes
advertised by the PE..
import-route protocol [ process-id
| allow-ibgp ] [ cost value |
route-policy route-policy-name |
type type ] *
By default, no route of any other
routing protocol is redistributed
into OSPFv3.
5. Return to system view.
quit N/A
6. Enter interface view.
interface interface-type
interface-number
N/A
7. Enable OSPFv3 on the
interface.
ospfv3 process-id area area-id
[ instance instance-id ]
By default, OSPFv3 is disabled on
an interface.
NOTE:
Deleting a VPN instance also deletes all related OSPFv3 processes.
Configuring IPv6 IS-IS between IPv6 MCE and VPN site
An IPv6 IS-IS process belongs to the public network or a single IPv6 VPN instance. If you create an IPv6
IS-IS process without binding it to an IPv6 VPN instance, the process belongs to the public network.
By configuring IPv6 IS-IS process-to-IPv6 VPN instance bindings on an IPv6 MCE, you allow routes of
different IPv6 VPNs to be exchanged between the IPv6 MCE and the sites through different IPv6 IS-IS
processes, ensuring the separation and security of IPv6 VPN routes.
For more information about IPv6 IS-IS, see Layer 3—IP Routing Configuration Guide.
To configure IPv6 IS-IS between IPv6 MCE and VPN site:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an IPv6 IS-IS process
for a VPN instance and enter
IS-IS view.
isis [ process-id ] vpn-instance
vpn-instance-name
Perform this configuration on the
IPv6 MCE. On a VPN site,
configure normal IPv6 IS-IS.
3. Configure a network entity
title for the IS-IS process.
network-entity net Not configured by default.
4. Enable the IPv6 capacity for
the IPv6 IS-IS process.
ipv6 enable Disabled by default.