HP 10500 series

Ste
p
Command Remarks
5. Redistribute remote site routes
advertised by the PE.
ipv6 import-route protocol
[ process-id ] [ allow-ibgp ] [ cost
cost | [ level-1 | level-1-2 |
level-2 ] | route-policy
route-policy-name | tag tag ] *
Optional.
By default, no routes from any
other routing protocol are
redistributed to IPv6 IS-IS.
If you do not specify the route level
in the command, redistributed
routes are added to the level-2
routing table by default.
6. Return to system view.
quit N/A
7. Enter interface view.
interface interface-type
interface-number
N/A
8. Enable the IPv6 IS-IS process
on the interface.
isis ipv6 enable [ process-id ] Disabled by default.
Configuring EBGP between IPv6 MCE and VPN site
To use EBGP for exchanging routing information between an IPv6 MCE and IPv6 VPN sites, you must
configure a BGP peer for each IPv6 VPN instance on the IPv6 MCE, and redistribute the IGP routes of
each VPN instance on the IPv6 VPN sites.
If EBGP is used for route exchange, you also can configure filtering policies to filter the received routes
and the routes to be advertised.
1. Configure the IPv6 MCE:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 BGP-VPN instance
view.
ipv6-family vpn-instance
vpn-instance-name
N/A
4. Specify an IPv6 BGP peer in
an AS.
peer ipv6-address as-number
as-number
N/A
5. Redistribute remote site routes
advertised by the PE.
import-route protocol [ process-id
[ med med-value | route-policy
route-policy-name ] * ]
By default, No route redistribution
is configured.
6. Configure filtering of
redistributed routes.
filter-policy { acl6-number |
ipv6-prefix ip-prefix-name } export
[ direct | isisv6 process-id | ripng
process-id | static ]
Optional.
By default, the IPv6 MCE does not
filter redistributed routes.
7. Configure a filtering policy to
filter the received routes.
filter-policy { acl6-number |
ipv6-prefix ip-prefix-name } import
Optional.
By default, the IPv6 MCE does not
filter the received routes.
NOTE:
A
fter you confi
g
ure an IPv6 BGP VPN instance, the IPv6 BGP route exchange for the IPv6 VPN instance is
the same as the normal IPv6 BGP VPN route exchange. For more information about IPv6 BGP, see
Laye
r
3—IP Routing Configuration Guide .