TouchPad click board
Table 5-11 TouchPad click board part descriptions and part numbers
Description Spare part number
TouchPad click board L24486-001
TouchPad board cable L23184-001
TouchPad click board cable L24485-001
Before removing the TouchPad click board, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 31).
2. Remove the rubber feet (see Computer feet on page 31).
3. Remove the bottom cover (see Bottom cover on page 33).
4. Remove the battery (see Battery on page 35).
To remove the TouchPad click board:
1. Disconnect the TouchPad cable (1) from the system board, and then disconnect from the TouchPad click
board cable (2) TouchPad.
2. Remove the two Phillips M2.0 × 2.0 screws (3) that secure the TouchPad click board to the computer.
3. Lift the board (4), and then slide it outward from under the clips that hold it on place to remove it (5).
TIP: The edge of the board sits under clips. Be sure to slide the board out from under the clips to
prevent damage to the board or clips.
Reverse this procedure to install the TouchPad click board.
46 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
Need help?
General
