INSert
INSett
command
The INSert command allows you to add waveforms to the state waveform
display. Waveforms are added from top to bottom on the screen. When
24 waveforms are present, inserting additional waveforms replaces the last
waveform. Bit numbers are zero based, so a label with 8 bits is referenced
as bits O-7. Specifying
OVERlay
causes a composite waveform display of
all bits or channels for the specified label.
Command Syntax:
MACHine{
1 ~2):SWAVeform:INSert
c label-name
>
, <bit-id
z-
where:
c
label-name
>
:: = string of up to 6 alphanumeric characters
<bit-id
>
:: =
{OVERlay
1
c
bit-num
>
}
<bit
numz-
:: = integer representing a label bit from 0 to 31
Examples:
OUTPUT XXX;":MACHINEl:SWAVEFORM:INSERT 'WAVE', 19"
OUTPUT XXX;" :MACHINEl:SWAVEFORM:INSERT 'ABC', OVERLAY"
OUTPUT
XXX;":MACHl:SWAV:INSERT
'Pool'.
XB1001"
SWAVeform Subsystem
14-6
HP 1650B/HP 16518
Programming Reference
To Next Page
Loading...
