HP 166207-B21 - Smart Array 5302/32 RAID Controller - Page 89

HP Array Configuration Utility 89
Error
code
Error message Comment or clarification
2843 Invalid Size
The specified size is invalid or is not possible with
the current configuration.
2844 Invalid Stripe Size
The specified stripe size is invalid, not supported
by the current RAID level, or not possible with the
current configuration.
2849
Invalid ClearConfigurationWithDataLoss
parameter
The valid parameters are Yes and No (default).
2850
Controller does not support Chassis
Name
The controller does not support setting a chassis
name.
2851 Invalid Chassis Name
The entered chassis name is invalid. Use
characters from the set a–z, A–Z, 0–9, !, @, #, *,
(, ), ,, -, _, +, :, ., /, and [space]. The name
cannot end with a space character or exceed the
maximum number of characters allowed by the
controller.
2852 Invalid SSP State The requested SSP state is not a valid SSP state.
2853 Cannot change SSP settings
The SSP settings cannot be changed for the
controller or logical drive.
2854 Invalid SSP Adapter ID
The adapter ID is not a valid adapter ID that was
detected by the controller.
2857 Invalid Surface Scan Delay —
2861
Controller does not support redundancy
settings
The controller is not redundant or does not
support redundancy settings.
2864 Invalid Preferred Path Mode
The specified value for the preferred path mode is
not valid, or the controller is not available.
2865 Invalid Preferred Path
The specified preferred path is not a valid chassis
slot for an available, active controller, or the
controller is not available.
2866 Failure opening capture file <text> —
2867 Failure opening input file <text> —
2868 Failure opening error file <text> —
2877 There are no suitable spares available
ACU found no drives that could be used as spares
for the specified array.
2880 Invalid Physical Disk Type Specified —
2882 Invalid MNP delay The specified value for MNP delay is invalid.
3000 Invalid Option
The value of the option supplied to this parameter
is invalid.
3002 Command Failed The controller returned an error for a command.
3003 License Key Delete Failed ACU is unable to delete the license key.
3004 Invalid Sector Size —
3005 Cannot delete Array —