HP Array Configuration Utility 90
Error
code
Error message Comment or clarification
3006 Invalid Number of Parity Groups —
3007 Chassis name is too long —
3008 Chassis name is already in use
Another controller is already using the entered
chassis name.
3009 Auto Configure failed
The Auto Configure mode was unable to complete
auto configuration.
3010
Cannot extend logical drive, not enough
free space for the requested size
—
3011
Cannot extend logical drive, requested
size is too small
—
3012
Cannot specify both SIZE and
SHRINKSIZE
The input file cannot specify both a SIZE and
SHRINKSIZE parameter.
3013 Cannot shrink Array The array shrink operation was not successful.
3014 Cannot move Array The array move operation was not successful.
3015
Invalid operation - Advanced Pack
support required
The requested operation requires a valid license
key to be entered.
3016
Spare drives cannot be specified by a
count in Reconfigure mode
When in Reconfigure mode, the requested spare
drives must be specified by their addresses. A
simple count cannot be used.
3017
Disk drives cannot be specified by a
count in Reconfigure mode
When in Reconfigure mode, the requested data
drives must be specified by their addresses. A
simple count cannot be used.
3018 Invalid number of physical disks —
3019
Cannot create Array - no physical disks
specified
ACU cannot create an array unless physical disks
are specified in the input file DRIVE parameter.
3020
SSP must be enabled in order to perform
this operation
For the specified operation, ACU requires SSP to
be supported and enabled.
3021 Invalid connection name —
3022
The connectionname cannot be
removed when the hostmode has a non-
default value.
—
3023 Invalid Host Mode —
3024 Invalid Adapter ID —
3025
This controller does not have host mode
modification capability
—
3026
You need to have administrator rights to
continue.
—
3027
Another instance of ACU is already
running (possibly a service). Please
terminate the ACU application before
running ACU scripting.
—
To Next Page
Loading...
