Installation procedures—All deployments20
QLogic Driver for HBA Control and
Multipathing
http://h18006.www1.hp.com/
products/sanworks/
multipathoptions/index.html
Multipathing tool for Linux (active/passive and active/active environments)
Used in multipathing environments running either active/passive or
active/active firmware, QLogic Driver for HBA Control and Multipathing
provides multipathing support for Linux environments.
This multipathing tool is included with the QLogic HBA driver on the MSA
Support Software CD.
Emulex MultiPulse Path Failover for
Linux
http://h18006.www1.hp.com/products/
sanworks/softwaredrivers/multipathoptions
/linux.html
Multipathing tool for Linux (active/active environments only)
Used in multipathing environments running active/active firmware, Emulex
MultiPulse provides multipathing support for Linux environments.
MultiPulse is included with the Emulex Linux HBA driver on the MSA
Support Software CD.
NOTE: Emulex MultiPulse is supported for use with Linux kernel
2.6 or later only. No support is provided or planned for earlier
Linux kernels.
Array Configuration Utility (ACU)
Array Configuration Utility - Command
Line Interface (ACU-CLI)
h18000.www1.hp.com/products/
servers/proliantstorage/
software-management/acumatrix/
index.html
Storage configuration software (active/passive and active/active
environments)
The Array Configuration Utility (ACU) is a server-based, browser-accessed
tool used to configure an array controller and its storage. The ACU can be
used in Windows, Linux, and NetWare environments. (NetWare
environments run the ACU directly from the MSA Support Software CD.)
The Array Configuration Utility-Command Line Interface (ACU-CLI) is a
command line interface used to configure an array controller and its
storage. The ACU-CLI is primarily used in HP-UX environments.
These utilities are provided on the MSA Support Software CD.
Table 3 MSA1000 and SAN-related websites (continued)
Website Content
To Next Page
Loading...
Need help?
General
