HP 39gs - Page 257

Programming 18-35
S1mark–S5mark
Statistics
Sets the mark to use for scatter plots.
From Plot Setup for two-variable statistics, S1mark-
S5mark, then choose a mark.
or
In a program, type
n
 S1mark
where n is 1,2,3,...5
SeqPlot
Sequence
Enables you to choose types of sequence plot: Stairstep
or Cobweb.
From Plot Setup, select SeqPlot, then choose
Stairstep or Cobweb.
or
In a program, type
1
 SeqPlot—for Stairstep.
2
 SeqPlot—for Cobweb.
Simult
Function
Parametric
Polar
Sequence
Enables you to choose between simultaneous and
sequential graphing of all selected expressions.
From Plot Setup, check (or uncheck) _SIMULT
or
In a program, type
1
 Simult—for simultaneous graphing (default).
0
 Simult—for sequential graphing.
Slope
Function
Contains the last value found by the Slope function in the
Plot-FCN menu.
StatPlot
Statistics
Enables you to choose types of 1-variable statistics plot
between Histogram or Box-and-Whisker.
From Plot Setup, select StatPlot, then choose
Histogram or BoxWhisker.
or
In a program, type
1
 StatPlot—for Histogram.
2  StatPlot—for Box-and-Whisker.
HP 39gs English.book Page 35 Wednesday, December 7, 2005 11:24 PM