Typically the State is listed as Loss sync, the Mode as Initiator and the Connected
Device Type as Free.
3. Verify that the SFP has been successfully replaced by refreshing the above pane.
State should now be listed as Ready, the Mode as Target and the Connected Device Type
as Host.
To perform maintenance using CLI, access SPMAINT:
1. In the 3PAR Service Processor Menu, select option 7 Interactive CLI for an InServ.
2. Issue the following commands:
• showport to view the port State:
s750 cli%showport
N:S:P Mode State Node_WWN Port_WWN/HW_Addr Type Protocol
Label Partner FailoverState
0:0:1 initiator ready 50002ACFF70185A6 50002AC0010185A6 disk SAS
- - -
0:0:2 initiator ready 50002ACFF70185A6 50002AC0020185A6 disk SAS
- - -
0:1:1 target ready 2FF70002AC0185A6 20110002AC0185A6 host FC
- - -
0:1:2 target ready 2FF70002AC0185A6 20120002AC0185A6 host FC
- - -
0:2:1 target loss_sync - 2C27D75301F6 iscsi iSCSI
- - -
0:2:2 target loss_sync - 2C27D75301F2 iscsi iSCSI
22 Servicing the Storage System
To Next Page
Loading...
Need help?
General