• 1 for Update SP Software Revision
• 2 for CDROM to install the files.
NOTE: The installation process takes approximately five minutes.
4. When prompted to update the SP, verify that the software version is correct. Type y and press
Enter to continue with the update process.
Mounting CDROM...
Using spinstaller from /sp/sw/sp/2.5.1.GA-15/
tpdSPInFormOS3.1.2.226-3.1.2.226-12.i386.rpm
Do You wish to update the SP from /mnt/cdrom?
(y or n)
y
5. When the installation process completes, the SPMAINT main menu reappears. To verify the
current software versions after installation, type 1 for SP Control/Status.
1 SP Main
3PAR Service Processor Menu
Transfer media: ethernet Transfer status: Ok
Enter Control-C at any time to abort this process
1 ==> SP Control/Status
2 ==> Network Configuration
3 ==> InServ Configuration Management
4 ==> InServ Product Maintenance
5 ==> Local Notification Configuration
6 ==> Site Authentication Key Manipulation
7 ==> Interactive CLI for an InServ
X Exit
1
6. Type 1 for Display SP Version to verify installation is complete.
1.1 Display SP Version
SP Software Version
SP-4.1.0.GA-97
SP Base Image Version: Red Hat Enterprise Linux Server release 6.1
(Santiago)
SP Version: 4.1.0.GA-97
SP Patches:
InFormOS release (3.1.2): 3.1.2.370
More detail is available in the latest SPLOR or spconfig data.
Press to continue
Continue to “Adding a Storage System to the Service Processor” (page 50).
Installing HP 3PAR OS Files 49
To Next Page
Loading...
Need help?
General