To Output GRAPHICS Data to Printer/Plotter
1. Display the GRAPH/LIST: GRAPH page to output.
2. Press
4
Plot/Print
5
front-panel key. The GRAPH PLOT setup window is
displayed.
3.
In the DESTINATION eld, select
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
PRINTER/PLOTTER
secondary softkey.
4. (For HP-GL only) In the GRAPH TRACE ONLY eld, select:
NNNNNNNNNNN
YES
secondary softkey to output graph trace only.
NNNNNNNN
NO
secondary softkey to output graphics with items that are enabled in
the OUTPUT ITEMS table of the SYSTEM: PRINT/PLOT SETUP page.
For PCL, the graph trace is always output, so this eld does not appear
.
5. (Optional) In the PRINT/PLOT COMMENT eld, enter a comment.
maximum characters: 58
6. (Optional) In the PRINT SETUP DATA eld, select:
N
NNNNNNNNNN
YES
secondary softkey to output graphics with measurement setup
data.
NNNNNNNN
NO
secondary softkey to output graphics only.
7.
Select
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
PRINT/PLOT
primary softkey. Output is performed.
8.
Select
NNNNNNNNNNNNNN
EXIT
primary softkey to exit GRAPH PLOT setup window.
The PRINT/PLOT COMMENT is output
only
if ENABLE is set in the
PRINT/PLOT COMMENT eld of the OUTPUT ITEM table on the SYSTEM:
PRINT/PLOT SETUP page.
For details about setting up the OUTPUT REGION table
, refer to \GRAPH
PLOT Window".
The settings of the GRAPH PLOT setup window can be stored onto diskette
as part of CST type setup data le, which is for customizing system data. To
store the settings, refer to \To Store Hardcopy Image to Diskette".
1-14
To Next Page
Loading...
Need help?
General
