2
Determine the installation position by observing the following principles:
• To meet regulatory RF exposure requirements, install the device at a location where the radiating
antenna can be kept 40 cm (15.75 in) from any person.
• Leave as few obstacles (such as wall) as possible between APs and clients.
• Install APs away from electronic devices (such as microwave ovens) that might generate radio
frequency (RF) noise.
• Do not install APs in a place where water seeping, water soaking, and condensing occur. Prevent
water or moisture from entering the APs.
• Do not place the device on any metal surface. Place it where there are no obstacles and good
signal strength is available.
Accessories provided with the AP
ARNING!
Only use the antennas which have been approved by the applicant. Unapproved antenna(s) may produce
unwanted spurious or excessive RF transmitting power, which is prohibited and could be in violation of
FCC/IC limits.
Wall-mounting bracket T-rail holder
MAC address label T-rail holder mounting screw
Wall anchor kit Rubber feet
Hex-head bolt, washer, and nut
Antennas, power adapter, and power cable are user-supplied.
To Next Page
Loading...
Need help?
General
