HP 425 User Manual

4
Installing the AP
Figure 1 Installation flowchart
The device can only be used indoors and has built-in antennas. When you install the AP, determine
whether external antennas are needed. External antennas are not included with the AP and this
document does not include external antenna installation procedures.
Mounting the AP on a table
1. Attach the rubber feet supplied with the AP to the rear of the AP as shown in Figure 2.
Figure 2 Attaching the rubber feet

HP 425 Specifications

General

Device Type	Wireless Access Point
Product Name	HP 425
Maximum Data Rate	300 Mbps
Ethernet Ports	1
Wireless Protocol	802.11n
Frequency Band	2.4 GHz
Antennas	2 internal antennas
Power Source	Power over Ethernet (PoE) or External Power Adapter
Security Features	WPA, WPA2, WEP, 802.1X