EasyManuals Logo

HP 425 User Manual

HP 425
27 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
3
Installation preparation checklist
Before you install an AP, verify the following items:
Connect the power cord and connect the AP to the network. Examine the LED status to make sure
the AP can operate correctly. For more information about AP LEDs, see "Appendix B LEDs."
V
erify that cabling has been completed.
The device supports 802.3af-compliant PoE. To achieve the best performance, HP recommends that
you use a GE connection to the power device.
Record the MAC address and serial number of the AP (marked on the rear of the AP) for future use.
If part of the power line is routed outdoors, use a power strip with lightning protection (user supplied)
to connect the power cord of the AP to the power line.

Other manuals for HP 425

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 425 and is the answer not in the manual?

HP 425 Specifications

General IconGeneral
Device TypeWireless Access Point
Product NameHP 425
Maximum Data Rate300 Mbps
Ethernet Ports1
Wireless Protocol802.11n
Frequency Band2.4 GHz
Antennas2 internal antennas
Power SourcePower over Ethernet (PoE) or External Power Adapter
Security FeaturesWPA, WPA2, WEP, 802.1X

Related product manuals