Chapter 3 Programming Your Universal Counter for Remote Operation
How to Program the Counter to Define Macros
3-54 Programming Guide
*DMC ‘limitdisplay ’,#268
:DISP:MENU 0;TEXT:FEED ‘CALC2’;:CALC2:LIM:STAT 1;DISP
GRAP;
:CALC:IMM
Programming examples using macros are provided in the following section titled
“Programming Examples.” The first macro program listing (starting on page 3- 75)
uses HP BASIC for an HP 9000 series 300 computer. The second Macro program
listing (starting on page
3-88) is for an IBM PC (or clone) and HP 82335A/B card. Both are softkey
driven and can be used to define macros, enable or disable macros, determine what
macros are available and purge macros. There is little error trapping in the
programs, if you misspell a command, the Counter will give an error message.
To Next Page
Loading...
