HP 53131A/132A 225 MHz - RCL <Nrf> (Recall Command)

Chapter 4 Command Reference
*RCL <NRf>
(Recall Command)
4-136 Programming Guide
*RCL <NRf>
(Recall Command)
*RCL <NRf>
This command restores the state of the instrument from a copy stored in local non-
volatile memory. Before the recall occurs, the current state of the instrument is
automatically saved to register 0.
0 to 20
1
The following commands/states are unaffected by *RCL:
*EMC
*ESE
*OPC
*OPC?
*SRE
*WAI
:CALibration:COUNt?
:CALibration:DATA
:CALibration:SECurity:CODE
:CALibration:SECurity:STATe
:CONFigure?
:DIAGnostic:CALibration:INTerpolator:AUTO
:DISPlay:ENABle
:DISPlay:MENU[:STATe]
:DISPLay[:WINDow]:TEXT:RADix
[:SENSe]:FREQuency:EXPected[1|2|3]
[:SENSe]:FREQuency:EXPected[1|2|3]:AUTO
[:SENSe]:ROSCillator:EXTernal:CHECk
[:SENSe]:ROSCillator:SOURCe
[:SENSe]:ROSCillator:SOURCe:AUTO
:STATus:OPERation:ENABle
:STATus:OPERation:NTRansition
:STATus:OPERation:PTRansition
:STATus:QUEStionable:ENABle
:STATus:QUEStionable:NTRansition
:STATus:QUEStionable:PTRansition
:SYSTem:COMMunicate:SERial:CONTrol:DTR
:SYSTem:COMMunicate:SERial:TRANsmit:BAUD
:SYSTem:COMMunicate:SERial:TRANsmit:PACE
:SYSTem:COMMunicate:SERial:TRANsmit:PARity[:TYPE]
:SYSTem:ERRor? (error queue)
:SYSTem:KEY? (key queue)
:SYSTem:KEY:LOG? (key queue)
HP-IB Address
<NRf> Range
<NRf>
Resolution
Comments