HP 53131A/132A 225 MHz - [:Sense]:Phase Subtree; [:Sense]:Phase:arm Subtree

Chapter 4 Command Reference
Introduction
Programming Guide 4-91
• When the sensor function is changed resulting in auto-trigger being enabled,
the Counter will wait until a measurement is initiated before performing the
first “auto-trigger” and updating the absolute level(s).
• This command has no direct effect on :FETCh?, :READ?, or :CONFigure?.
• When the sensor function is Totalize, Voltage Minimum, Voltage Maximum,
or Voltage Peak-to-Peak, then [:INIT]:IMM always initiates a single
measurement.
Freq & Ratio, Time & Period, and Other Meas
[:SENSe]:PHASe Subtree
This subtree controls the Phase measuring capabilities of the instrument.
[:SENSe]:PHASe:ARM Subtree
This subtree is used to synchronize the Phase start arm with events.
STARt:SOURce Front-Panel Arming Mode
IMMediate AUTO
EXTernal EXTERNAL
[:SENSe]:PHASe:ARM[:STARt]:SLOPe POSitive | NEGative
Sets or queries the slope of the external start arm signal used in external arming
Phase measurements.
A sequence of ASCII-encoded bytes: POS or NEG
• *RST: POSitive
• Only applies when [:SENS]:PHAS:ARM[:STAR]:SOUR EXT is selected.
Gate & ExtArm
Related
Front-Panel
Keys
Query Response
Comments
Related
Front-Panel
Keys