Chapter 4 Command Reference
Introduction
Programming Guide 4-127
*ESE <NRf>
(Standard Event Status Enable Command)
*ESE?
(Standard Event Status Enable Query)
*ESE <NRf>
*ESE?
Sets or queries the Standard Event Status Enable Register, shown in Figure 4-4.
The parameter and query response value, when rounded to an integer value and
expressed in base 2 (binary), represents the bit values of the Standard Event
Status Enable Register. The value of unused bits is zero when queried and ignored
when set.
This register is used to enable a single or inclusive OR group of Standard Event
Status Register events to be summarized in the Status Byte Register (bit 5).
Figure 4-4. The Standard Event Status Enable Register
See the section titled “Standard Event Status Register Group,”
page 3-24, in Chapter 3 of this guide for a detailed description of the Standard
Event Status Register.
0 to 255
1
Numeric data transferred as ASCII bytes in <NR1> format.
• At power-on, the Standard Event Status Enable Register is cleared (value is
0).
• This value is unaffected by *RST and save/recall.
<NRf> Range
<NRf>
Resolution
Query Response
Comments
To Next Page
Loading...
