HP 53131A/132A 225 MHz - Page 33

Chapter 2 Command Summary
Front Panel to SCPI Command Maps
Programming Guide 2-9
MEASURE Keys to SCPI Command Map (Cont.)
1 a. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]FREQuency [1 | 2 | 3] ”
b. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]FREQuency:RATio
[1,2 | 1,3 | 2,1 | 3,1]”
2 a. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]TOTalize [1] ”
b. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]PHASe [1,2] ”
c. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]DCYCle [1] ”
d. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]VOLTage:MINimum [1] ”
OR
[:SENSe]:FUNCtion[:ON] “[:][XNONe:]VOLTage:MAXimum [1] ”
e. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]VOLTage:MINimum 2 ”
OR
[:SENSe]:FUNCtion[:ON] “[:][XNONe:]VOLTage:MAXimum 2 ”
3 a. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]TINTerval [1,2] ”
b. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]PERiod [1] ”
c. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]RISE:TIME [1] ”
d. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]FALL:TIME [1] ”
e. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]PWIDth [1]”
f. [:SENSe]:FUNCtion[:ON] “[:][XNONe:]NWIDth [1]”
Since the primary purpose of these front-panel keys is to change the function, the
corresponding [:SENSe]:FUNCtion[:ON] command is listed in the menu map
above. The front-panel keys, however, invoke couplings which affect other
settings, whereas the [:SENSe]:FUNCtion[:ON] command does not.
Figure 2-3. MEASURE Keys to SCPI Command Map (Part 2 of 2)