Contents
vi Programming Guide
Event Status Register 3-39
Using the Questionable Data/Signal Status Register to Alert the Computer
When Automatic Interpolator Calibration is Disabled—Example 3 3-39
Questionable Data Status Register 3-40
Using the Operation Status Register to Alert the Computer When
Measuring has Completed— Example 4 3-40
Operation Status Register 3-40
How to Program the Counter to Display Results 3-43
Configuring the Counter’s Display 3-43
Commands for Displaying Non-Scaled/Offset Results 3-43
Commands for Displaying Scaled/Offset Results 3-44
Commands for Displaying the Limit Graph 3-44
Commands for Displaying Statistics Results 3-44
Commands for Enabling and Disabling the Display 3-45
How to Program the Counter to Synchronize Measurements 3-46
Synchronizing Measurement Completion 3-46
Resetting the Counter and Clearing the HP-IB Interface 3-46
Using the *WAI Command 3-46
Using the *OPC? Command 3-47
Using the *OPC Command to Assert SRQ 3-48
How to Program the Counter for Math/Limit
Operations 3-49
Updating Math and Limit Results Over HP-IB 3-49
Using the Scale and Offset Over HP-IB 3-50
How to Program the Counter to Define Macros 3-52
Writing SCPI Programs 3-55
Programming Examples 3-58
Using HP BASIC 3-58
To Send a Double-Quoted String 3-58
To Send a Single-Quoted String 3-58
Using QuickBASIC 3-59
Using Turbo C 3-59
List of the Programming Examples 3-59
Easiest Way to Make a Measurement (HP BASIC) 3-60
To Make a Frequency Measurement (HP BASIC) 3-62
To Next Page
Loading...
