10
2. Mark the position on the rack for installing the slide rail.
a. Make sure the bottom edge of the slide rail aligns with the middle of the narrower metal area
between holes, as shown in Figure 5.
b. Ea
ch rack post requires six screws to fix the slide rail. You only need to mark the uppermost
square hole and lowermost square hole for installation.
c. Mark the square holes at the same height on the other three rack posts.
One rack unit has three holes, the middle of which is an auxiliary installation hole, and the
other two are standard installation holes. You can distinguish them by the space between each
two holes. The space between a standard installation hole and an auxiliary installation hole is
larger than that between two adjacent standard installation holes.
Figure 5 Locating the rack position for installing slide rails
(1) Middle of the narrower metal area between holes
3. Install six cage nuts on the square holes in each rack post, as shown in Figure 6.
Figure 6 Installing a cage nut
4. Align the installation holes on the front end of the slide rail with the cage nuts on the front rack post,
and attach them with screws, as shown in Figure 7.
To Next Page
Loading...
