20
Installing FRUs
There is no required order for installing FRUs. HP recommends that you connect power cords after
completing installing all required FRUs.
TIP:
Keep the chassis and the component packages for future use.
Attaching an ESD wrist strap
Every 7500 switch provides an ESD wrist strap. To minimize ESD damage to electronic components,
wear an ESD wrist strap and ensure it is well grounded when installing modules.
To attach an ESD wrist strap:
1. Make sure the switch is well grounded. For how to ground your switch, see "Installing the switch."
2. Wear the wrist strap.
3. Tighten the wrist strap to keep good skin contact. Make sure the resistance reading between your
body and the ground is between 1 and 10 megohms.
4. As shown in Figure 17, in
sert the ESD wrist strap into the ESD port on the switch chassis, or attach
it to the grounding screw of the chassis with an alligator clip.
Figure 17 Attaching an ESD-prevent wrist strap (7503 as an illustration)
(1) ESD wrist strap port (havin
To Next Page
Loading...
