HP 7500 Series - Displaying the Basic IRF Settings of IRF Member Switches; Displaying IRF Topology Information

70
Field Descri
p
tion
Auto merge
Whether the auto-reboot for IRF fabric merge is enabled:
• yes—Enabled
• no—Disabled
Displaying the basic IRF settings of IRF member switches
Use the display irf configuration command to display the basic IRF settings that take effect after member
switches reboot, including their member IDs, priority, and IRF port bindings.
• Display the basic IRF settings that take effect after the member switch reboots when it is operating
in standalone mode:
<Sysname> display irf configuration
MemberID Priority IRF-Port1 IRF-Port2
1 1 Ten-GigabitEthernet2/0/1 disable
• Display the basic IRF settings of all member switches after the member switches reboot and the IRF
fabric is formed:
<Sysname> display irf configuration
MemberID NewID IRF-Port1 IRF-Port2
1 1 Ten-GigabitEthernet1/2/0/1 disable
Ten-GigabitEthernet1/2/0/2
2 2 disable Ten-GigabitEthernet2/3/0/1
Ten-GigabitEthernet2/3/0/2
Table 23 Command output
Field Descri
p
tion
MemberID
Current member ID of the device.
If no member ID has been assigned, this field displays two hyphens (--).
Priority
Member priority.
This field is available only in standalone mode.
New-ID
The member ID re-assigned to the switch. This setting takes effect at reboot.
This field is available only in IRF mode.
IRF-Port1
Ports bound to IRF port 1. To bring up IRF port 1, you must bind at least one
physical port to it. If no ports have bound to IRF port 1, this field displays disable.
IRF-Port2
Ports bound to IRF port 2. To bring up IRF port 2, you must bind at least one
physical port to it. If no ports have bound to IRF port 2, this field displays disable.
Displaying IRF topology information
Use the display irf topology command to display IRF topology information.
<Sysname> display irf topology
Topology Info
-------------------------------------------------------------------------
IRF-Port1 IRF-Port2
Switch Link neighbor Link neighbor Belong To