39
{ For an SFP+ module, press the module down against the upward force of the bottom spring tab
so you can push the module straight into the port.
{ If you cannot hold the module by its two sides because of high module density, press the module
on its head end to push it in.
4. Connect the fiber to the module. For the installation procedure, see "Connecting your switch to the
network."
Figure 34 Installing an XFP/SFP+/SFP/QSFP+ mo
dule
Installing a CFP module
1. Wear an ESD wrist strap and make sure it makes good skin contact and is well grounded. For
more information, see "Attaching an ESD wrist strap."
2. Unpack the CFP module. Do not touch the golden f
inger of the module.
3. Holding both sides of the module, gently push the module into the slot until it has firm contact with
the slot. See Figure 35.
4. Fasten the
captive screws.
5. Connect the fiber to the module. For the installation procedure, see "Connecting your switch to the
network."
Figure 35 Installing a CF
P module
(1) Gently push the module into the slot (2) Fasten the captive screws
1
2
2
To Next Page
Loading...
