HP 7500 Series - Page 31

25
Figure 21 Panel view of the 1400W AC
(1) Captive screws
(2) Power switch (O
for off, and | for on)
(3) Status LEDs (4) AC receptacle
(5) Hole for fixin
g
a cable tie (6)
Power supply handle
To connect the AC power cord:
1. Make sure of the power cord model (the 1400W AC uses a 16 A AC power cord).
2. Plug the power cord to the power receptacle on the power supply, and ensure a good contact.
3. Secure the power cord to the power supply handle by using a cable tie, as shown in Figure 22.
4. Plug the oth
er end of the power cord to the AC power receptacle of the power source.
5. Turn on the power switch.
6. Examine the power supply input status LED.
If the LED is green, the power cord is correctly connected. If the LED is off or red, examine the
installation, and solve the problem. Then switch on the power supply to verify that the LED is green.
For description of 1400W AC status LEDs, see "Appendix C LEDs."