Mounting the device on a workbench
If a standard 19-inch rack is not available, you can place a device on a clean, flat workbench, as follows:
1. Clean the recessed areas on the chassis bottom.
2. Attach the four rubber feet to the recessed areas on the chassis bottom.
3. Place the device on the workbench.
Avoid placing heavy objects on the device.
Figure 4 Mounting the device on a workbench
Installing the device in a 19-inch rack
You can install the device in a 19-inch rack by using the following methods:
Installing the device by using front and rear mounting brackets.
Installing the device by using front mounting brackets and a rack shelf.
Installing the device by using front mounting brackets and slide rails.
Mounting brackets
Figure 5 Front mounting bracket
9
To Next Page
Loading...
