I
-
I
-
Automating Measurements
Configuring Your Test System
Stand-Alone Analyzers
In this configuration, the measurement is controlled by an
IBASIC
program
Running IBASIC
running inside the analyzer. With
IBASIC,
the measurement setup and control
can be highly automated, reducing the burden on the operator. Since the
measurement is under programmatic control, statistics can be collected in
order to monitor your process and quality.
BASIC’s
keystroke recording lets
you construct programs quickly, without needing to refer to the programming
documentation. Using AUTOST files, the analyzer will load and run your
program when power is turned on.
Since no external computer is required, there are fewer system components
to purchase, maintain, connect, and synchronize.
Configure your system as a stand-alone instrument with
IBASIC
(Option
lC2)
if you would like to:
0
Simplify test system configuration
0
Allow for future expansion
l
Minimize the space required for a system
l
Simplify programming with keystroke recording
l
Use
IjEiQ
key macros
l
Automate measurement setup and control
0
Simplify measurements
l
Collect data
l
Run application programs on the analyzer
7-7
深圳市盛腾仪器仪表有限公司 Tel:0755-83589391 Fax:0755-83539691 Website: www.Sengt.com
To Next Page
Loading...
Need help?
General
