I
-
I
-
Getting Started
Entering Measurement Parameters
Presetting the Analyzer Press the
CPRESET)
key. When the analyzer is preset with the
C-1
key,
it reverts to a known operating condition. When this key is pressed, the
following major default conditions apply:
Frequency
range1
Frequency range*
Power level3
Measurement Channel 1
measurement
Measurement Channel 2
measurement
format
Number of points
Sweep time
Scale
Reference Level
System Bandwidth
0.3
to 1300 MHz
0.3
to
3000 MHz
0
dBm
Transmission
Off
tog Magnitude
201
Auto
10
dB/div
0
dBm
Medium Wide
1 HP 8711C only
2 HP 8713C only
3 Preset power level can be set to other than
0
dBm
if desired. See “Entering
Source Power Level,” later in this chapter for more information.
NOTE
The measurement parameters that you enter will be retained in the analyzer’s memory when the
power is turned off, and will be restored when the power is turned back on.
See Also
Refer to Chapter 12, “Preset State and Memory Allocation,” for a comprehensive table of preset
conditions.
2-6
深圳市盛腾仪器仪表有限公司 Tel:0755-83589391 Fax:0755-83539691 Website: www.Sengt.com
To Next Page
Loading...
Need help?
General
