HP 8711C User Manual

I
-
I
-
Making Measurements
Using the BEGIN Key to Make Measurements
Depending on your selection, the analyzer is set to one of the following
configurations. (The SRL and Fault Location configurations are discussed in
the Option 100 User’s Guide Supplement.)
Table 3-l. Measurement Configurations from the [BEGIN) Key
Frequency Range2
Frequency Range3
Power Level
Transmission
Reflection Power Conversion Loss
AM Dolay
0.300 MHz-1300 MHz 0.300 MHz-1300 MHz 10 MHz-1300 MHz 10 MHz-1300 MHz IO MHz-1300 MHz
0.300 MHz-3000 MHz 0.300 MHz-3000 MHz 10 MHz-3000 MHz 10 MHz-3000 MHz 10 MHz-3000 MHz
preset power level4 preset power level4
preset power level4 preset power level4 maximum specified5
Measurement Channel 1
Measurement Channel 2
Transmission
off
Reflection
Off
Power
off
Conversion loss
Off
AM Delay
Off
Format
Number of Points
Sweep Time Mode
Sweep Triggering
Detection Mode
Measurement Paths
Averaging
h Ma!
201
Auto
h Ma!
201
Auto
h Ma!
201
Auto
log Ma!
201
Auto
N/A
201
Auto
Continuous
Narrowbend
Continuous
Narrowband
Continuous Continuous
Continuous
Broadband Internal Broadband Internal Broadband External
B/R
Am
B”
B’IR”
Y/X
Off Off Off
Off
Off
System Bandwidth Medium Wide Medium Wide
Medium Wide Medium Wide
Narrow
1 Options IDA and 106 only
2 HP 8711C
3 HP 8713C
4 Preset power level is user-defined by using the Preset Pwr Level softkey The factory default is 0 dBm.
5 Maximum power is dependent upon the option configuration of your analyzer. See Chapter 10 to determine the maximum specified power for your analyzer.
3-16
深圳市盛腾仪器仪表有限公司 Tel:0755-83589391 Fax:0755-83539691 Website: www.Sengt.com

HP 8711C Specifications

General

Brand	HP
Model	8711C
Category	Measuring Instruments
Language	English