HP 8753E - Page 107

‘able l-11. HP-II3 Only Commands (continued)
Action
Mnemonic S ?
Description
OUTPUT (continued)
%-e-raw
OUTPPREI
1
Array 1 (Sll data). Analogous to OUTPRAW
lata
except that pre-raw data has not had sampler
correction nor attenuator offsets applied. Use ir
conjunction with ‘lake4 mode only.
OUTPPREZ
1
Array 2 (S21 data).
OUTPPRES 1 Array 3 (512 data).
OUTPPRE4 1 Array 4 (522 data).
‘rint
OUTPPRIN
1
Outputs the print string of the display graphics.
OUTPPRNALL 1 Outputs all pages List Values or current page of
Operating and marker parameters in ASCII.
Activate the desired function with LISV to prinl
values or OPEP to print operating parameten
prior to this command.
Saw data
OUTPRAW 1 1
Array 1 (Sll data).Outputs uncorrected data
arrays for the active channel. Raw 1 holds the
single parameter data unless a 2-port calibratior
is on, in which case raw 1 holds Sll and the
following arrays hold S21, 512, and S22,
respectively. The data is in real/imaginary pain
OUTPRAWZ
1
Array 2 (521 data).
OUTPRAW3 1
Array 3 (S12 data).
OUTPRAW4 1
Array 4 (S22 data).
OUTPRAF< I> 1
F&t data transfer command for OUTPRAW<I>.
*ternal
OUTPRFFR 1
Outputs external source RF frequency when in
source
external source instrument mode.
iimit test
OUTPSEGAF’ 1
Outputs the segment number and its limit test
itatus
status
§
for all active segments.
t
MinImax
OUTPSEGAM’ 1
Outputs limit test minImax all segs. Outputs the
ralues
segment number, max stimulus, max value, min
stimulus, min value for all active segments.
t
’ Refer to the “Limit Line and Data Point Special Functions” section in HP E45’K
Programming h!m?npks Guide
i Values returned for limit test status are: 1 (PASS), 0 (FAIL), - 1 (NO-LIMIT)
1 For the definition of a limit segment, see “Example Display of Limit Lines” in the
HP BASIC Progranzming ,?!%ompeS G&de section titled “Limit Line and Data Point
Special Functions.”
l-100 HP-IB Programuu
‘ng and Command Reference Guide