MANTRIG
Sets the external trigger to manual trigger
on point. OPC-compatible.
These commands make the indicated marker active and set its stimulus
value. Range: stimulus range.
MARKl[D]
Marker 1.
MARK2
[D]
Marker 2.
MARK3
[D]
Marker 3.
MARKI[D]
Marker 4.
MARK5[D]
Marker 5.
MARKBUCK[D]
Places the active marker on a
specific sweep point (bucket).
D is the bucket number.
MARKCENT
Range: 0 to number of points less 1.
Sets the center stimulus value to that of
the active marker’s stimulus value.
MARKCONT
Places the markers continuously on the
trace, not on discrete points (interpolates
the marker values between discrete
points).
MARKCOUP
MARKCW
MARKDELA
MARKDISC
MARKFAUV[D]
MARKFSTI[D]
Couples the markers between the
channels, as opposed to MARKUNCO.
Sets the CW frequency to the active
marker’s frequency.
Sets electrical length so group delay is
zero at the active marker’s stimulus.
Places the markers on the discrete
measurement points.
Sets the auxiliary value of the fixed
marker position. Works in coordination
with
MARKFVAL
and MARKFSTI. Range:
amplitude range.
Sets the stimulus position of the fixed
marker. Range: stimulus range.
HP-IB
Progmmmin
g and Command Reference Guide
1-127
To Next Page
Loading...
