SAVE-d>
SAVEIWG<I>
Saves the current instrument state
in the indicated internal register.
OPC-compatible. Range: 1 to 5.
Saves to save/recall registers 01 through
3
1.
SAVEREGOl
through
SAVEREG05
are the same as
SAVE1
through
SAVE5.
OPC-compatible. Range: 01 to 31.
SAVT
Completes the
TRL/LRM
calibration
sequence. OPC-compatible.
The 2 following commands define the format for saving files to disk.
SAVUASCI
Selects ASCII format for saving to disk.
Conforms to CITIFile specifications.
SAVUBINA
Selects binary format for saving to disk.
SAVEUSEK
Stores the active calibration kit as the user
kit.
SCAL[D]
Sets the trace scale factor. Range:
amplitude range.
SCAP<FULLIGRAT>
Selects a full plot, or a plot where the
graticule is expanded to the plotter’s
Pl
and P2.
SDEL
During either a list frequency, a limit table
edit, or power loss list, deletes the current
segment.
SDON
During either a list frequency, a limit table
edit, or power loss list, closes a segment
after editing.
HP-IB Programm~
‘ng and Command Reference Guide
l-
147
To Next Page
Loading...
