These 2 commands are used in frequency offset mode measurements.
RFGTLO
Sets RF greater than LO.
RFLTLO
Sets RF less than LO.
RFLP
RIGL
RIGU
RSCO
Sameas
Selects a plot in the lower right quadrant.
Selects a plot in the upper right quadrant.
Resets display colors to the factory
default.
BST
Presets the instrument. OPC-compatible.
These 4 commands select the S-parameter for the active channel:
Sll
s12
s21
s22
SADD
SAMC
SAVl
SAV2
SAVC
During either a list frequency or limit
table edit, adds a new segment to the
table.
Selects whether sampler correction
is ON or OFF.
SAMC<ON(OFF>
and
RAWOFFS<ONIOFF>
are linked: when
one changes state, so does the other.
Completes the l-port calibration sequence.
OPC-compatible.
Completes the 2-port calibration sequence.
OPC-compatible.
Completes the transfer of error correction
coefficients back into the instrument.
OPC-compatible.
1-146 HP-IB Programming and Command Reference Guide
To Next Page
Loading...
