HP 8753E - Page 152

RECO
REFD
REFL
REFOP
are the same as RECAl through RECA5.
OPC-compatible. Range: 01 to 31.
Recalls previously saved display colors.
Completes the reflection calibration
subsequence of a 2-port calibration.
OPC-compatible.
Begins the reflection calibration
subsequence of a 2-port calibration.
Begins the reflection calibration
subsequence for one path, two port
calibration.
REFP[D]
REFT
REFV[D]
REIC[D]
RESC
RESD
Enters the reference position. 0 is the
bottom, 10 is the top of the graticule.
Range: 0 to 10.
Recalls file titles from disk.
Enters the reference line value. Range:
amplitude range.
Sets the power level reference value for
a receiver calibration. Range: stimulus
range.
Resume cal sequence.
Restores the measurement display after
viewing the operating parameters or list
values.
RESPDONE
Completes the response calibration
sequence. OPC-compatible.
REST
Measurement restart.
These commands (OPC-compatible) call the reverse calibration classes,
during a full 2-port calibration.
REV1
Isolation.
REVM
Match.
REVT
Transmission.
HP-IB Programrm
‘ng and Command Reference Guide
1-145