HP 8753E - Page 161

SSEG[D]
Selects the desired segment of the
frequency list for a list frequency sweep.
See also ASEG. Range: 1 to 30.
STB?
Outputs the status byte. Same as
OUTPSTAT.
The following 7 commands (OPC-compatible) select a standard from
a class during a calibration sequence. If a class is requested, as in
CLASSllA (Sll l-port Cal) the analyzer will do one of two things. If
there is only one standard in the class, it will measure that standard
automatically. If there are several standards in the class, then one of
the following commands must be used to select one of these standards,
causing it to be measured.
STANA Standard listed under softkey 1.
STANB Standard listed under softkey 2.
STANC
Standard listed under softkey 3.
STAND
Standard listed under softkey 4.
STANE Standard listed under softkey 5.
STANF
Standard listed under softkey 6.
STANG
Standard listed under softkey 7.
STAR[D]
Enters the start stimulus value. If a list
frequency segment is being edited, sets
the start of the segment. Range: stimulus
range.
STDD
Standard done, terminating a define
standard sequence, while modifying a cal
kit.
l-164 HP-IB Programmu
‘ng and Command Reference Guide