The following 5 commands select the standard “type” after the standard
number has been entered during a modify cal kit sequence:
STDTARBI
Arbitrary impedance.
STDTDELA
Delay/thru.
STDTLOAD
Load.
STDTOPEN
Open.
STDTSHOR
Short.
STOP[D]
Sets the stimulus stop value. If a list
frequency segment is being edited, sets
the stop of the segment. Range: stimulus
range.
These 5 commands store the indicated file on disk. Used with the INTD
and EXTD commands to designate the internal or external disk.
STORl Stores the current instrument state to
disk using the file name provided by the
preceding T I TF 1; command.
STORB
Stores the current instrument state to
disk using the file name provided by the
preceding T I
TF2;
command.
STOR3
Stores the current instrument state to
disk using the file name provided by the
preceding T I
TF3
i
command.
STOR4
Stores the current instrument state to
disk using the file name provided by the
preceding T I
TF4
3
command.
STOR5
Stores the current instrument state to
disk using the file name provided by the
preceding T I TF5
j
command.
STORSEQ<I>
Stores the instrument state of the
indicated sequence to disk. Used with the
INTD and EXTD commands to designate
the internal or external disk. Requires
pass control mode when using the HP-IB
port. Range: 1 to 6.
STPSIZE[D]
While editing a list frequency segment,
sets step size.
Iikznge:
stimulus range
HP-II3 Programrm
‘ng
and Command Reference Guide
1-155
To Next Page
Loading...
