Item Specification
Memory type and size
DDR2 SDRAM
1 GB (default, one 1 GB memory module)
2 GB (maximum)
NVRAM 128 KB
Combo interfaces
2
2 electrical interfaces
(automatic MDI/MDIX)
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
2 optical interfaces 1000 Mbps, full-duplex
HIM Not supported
MIM 4 MIMs supported at the same time
Dimensions (H × W × D) 45 × 399 × 412 mm (1.77 × 15.71 × 16.22 in.)
Hardware encryption Supported
Power consumption 50 W
hot-swapping Supported
For a Combo interface, the default operating interface is the electrical interface.
For a Combo interface, you can use either the electrical Ethernet interface or the optical
Ethernet interface. You can use the combo enable { copper | fiber } command in interface
view to switch between the optical and electrical interfaces. For details about the combo
enable { copper | fiber } command, refer to Ethernet Interfaces in the Access Volume of HP
SR6600 Routers User Manual.
Use optical transceivers provided by HP only. The device may be incompatible with other
optical transceivers and thus displays alarms automatically.
"Hot-swapping" a module refers to first using the remove slot slot-number command to stop
the module, and then manually pulling it out, or inserting the module into its slot without
powering off the device. For details about the remove slot command, refer to Device
Management in the System Volume of HP SR6600 Routers User Manual.
LEDs
Figure 1-15 FIP-100 LEDs
(1) LED for 10/100/1000 Mbps electrical Ethernet interface 0 (GE0)
(2) LED for 10/100/1000 Mbps electrical Ethernet interface 1 (GE1)
(3) 1000 Mbps optical Ethernet interface LED (SFP0)
To Next Page
Loading...
