The RPE-X1s of the device are hot-swappable. Use the remove slot slot-number command
before hot-swapping the RPE-X1.
When two RPE-X1s are installed on device, the ACT LED (green) is on.
For more information about the RPE-X1 LEDs, refer to Table 1-9 in Chapter 1 “Router
Overview.”
Removing an RPE-X1
1) For a device configured with only one RPE-X1, you need to power off the device before
removing the RPE-X1. Online removal of the RPE-X1 may cause damages to the RPE-X1,
FIPs, and HIMs/MIMs.
2) For a device configured with two RPE-X1s, you can remove one of the RSE-X1s when both of
them are operating normally.
To remove the active RPE-X1, you are recommended to use the slave switchover command
to implement manual active/standby switchover in system view of the active RPE-X1. For details
about this command, refer to HA in the System Volume of HP SR6600 Routers User Manual.
To remove the standby RPE-X1, follow steps mentioned below.
Follow these steps to remove an RPE-X1:
Step1 Face the front panel of the router.
Step2 Locate the RPE-X1 to be removed. The figures below illustrate how to remove the RPE-X1 in
Slot 5.
Step3 Loosen the captive screws counterclockwise with a Philips screwdriver until the all spring
pressure is released.
Figure 4-14 Loosen the captive screws on the RPE-X1
Step4 Pull the two ejector levers at both ends of the RPE-X1 outward to release the RPE-X1, and
then gently pull the RPE-X1 out along the slide rails.
To Next Page
Loading...
Need help?
General
