HP A6616 User Manual

Figure 4-15
Pull out the RPE
 To protect the removed RPE
-

If you do not install a new RPE
the chassis. For how to install a blank panel, refer to “
on page 4-38.
Installing an RSE-X1
Step1
Face the front panel of the router.
Step2
Locate the slot where you will install the
how to install an RPE-
X1 to Slot 5).
Step3 Gently push the RSE-
X1 into Slot 5 along the slide rails, and then push the ejector levers
inward to lock the board in position.
Pull out the RPE
-X1
-
X1, place it in an antistatic bag.
If you do not install a new RPE
-X1 in the slot, install a
blank panel to prevent dust from entering
the chassis. For how to install a blank panel, refer to “
Installing and Removing a Blank Panel
Face the front panel of the router.
Locate the slot where you will install the
RSE-
X1 (Slot 5 or Slot 6, the figures below illustrate
X1 to Slot 5).
X1 into Slot 5 along the slide rails, and then push the ejector levers
inward to lock the board in position.
blank panel to prevent dust from entering
Installing and Removing a Blank Panel
”
X1 (Slot 5 or Slot 6, the figures below illustrate
X1 into Slot 5 along the slide rails, and then push the ejector levers

HP A6616 Specifications

General

Brand	HP
Model	A6616
Category	Network Router
Language	English