HP A7533A - Brocade 4Gb SAN Switch Base - Deleting End-To-End Monitors; Filter-Based Performance Monitoring

410 Administering advanced performance monitoring
must match only the AL_PA portion of the specified SID-DID pair. Each port can have only one EE mask.
The mask is applied to all end-to-end monitors on the port. Individual masks for each monitor on the port
cannot be specified.
Figure 73 Mask positions for end-to-end monitors
Deleting end-to-end monitors
1. Connect to the switch and log in as admin.
2. Enter the perfMonitorShow command to list the valid end-to-end monitor numbers for a port.
3. Enter the perfDelEEMonitor command to delete a specific monitor.
If you do not specify which monitor number to delete, you are asked if you want to delete all entries.
The following example displays the end-to-end monitors on port 0 (the monitor numbers are listed in the
KEY column) and deletes monitor number 2 on port 0:
switch:admin> perfmonitorshow --class EE 0
There are 4 end-to-end monitor(s) defined on port 0.
KEY SID DID OWNER_APP TX_COUNT RX_COUNT OWNER_IP_ADDR
--------------------------------------------------------------------------------------
0 0x000024 0x000016 WEB_TOOLS 0x0000000000000000 0x0000000000000000 10.106.7.179
1 0x000022 0x000033 WEB_TOOLS 0x0000000000000000 0x0000000000000000 10.106.7.179
2 0x000123 0x000789 WEB_TOOLS 0x0000000000000000 0x0000000000000000 10.106.7.179
3 0x001212 0x003434 WEB_TOOLS 0x0000000000000000 0x0000000000000000 10.106.7.179
switch:admin> perfdeleemonitor 0, 2
End-to-End monitor number 2 deleted
switch:admin>
Filter-based performance monitoring
Filter-based performance monitoring counts the number of times a frame with a particular pattern is
transmitted by a port. Filter-based monitoring is achieved by configuring a filter for a particular purpose.
The filter can be a standard filter (for example, a SCSI read command filter that counts the number of SCSI
read commands that have been transmitted by the port) or a user-defined filter customized for your
particular use.
For the following switches, the maximum number of filters is 8 per port in any combination of standard
filters and user-defined filters:
• HP StorageWorks 4/8 SAN Switch
• HP StorageWorks 4/16 SAN Switch
• HP StorageWorks 8/8 SAN Switch
• HP StorageWorks 8/24 SAN Switches
• HP StorageWorks 8/80 SAN Switch
For the follwing switches, the maximum number of filters is 12 per port in any compination of standard
filters and user-designed filters:
• HP StorageWorks SAN Switch 4/32
• HP StorageWorks 4/64 SAN Switch
• HP StorageWorks SAN Switch 4/32B
perfsetporteemask 1/2, "00:ff:ff" "00:ff:ff" "00:ff:ff" "00:ff:ff"
SID mask DID mask
Transmitted from port
Received by port
AL_PA mask
Area ID mask
Domain ID mask
SID mask DID mask