HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Guide

296 Configuring the Distributed Management Server
8. Press Enter to update the nonvolatile memory and end the session.
switch:admin> msconfigure
0 Done
1 Display the access list
2 Add member based on its Port/Node WWN
3 Delete member based on its Port/Node WWN
select : (0..3) [1] 2
Port/Node WWN (in hex): [00:00:00:00:00:00:00:00] 20:00:00:20:37:65:ce:aa
*WWN is successfully added to the MS ACL.
0 Done
1 Display the access list
2 Add member based on its Port/Node WWN
3 Delete member based on its Port/Node WWN
select : (0..3) [2] 1
MS Access List consists of (14): {
20:00:00:20:37:65:ce:aa
20:00:00:20:37:65:ce:bb
20:00:00:20:37:65:ce:ff
20:00:00:20:37:65:ce:11
20:00:00:20:37:65:ce:22
20:00:00:20:37:65:ce:33
20:00:00:20:37:65:ce:44
10:00:00:60:69:04:11:24
10:00:00:60:69:04:11:23
21:00:00:e0:8b:04:70:3b
10:00:00:60:69:04:11:33
20:00:00:20:37:65:ce:55
20:00:00:20:37:65:ce:66
00:00:00:00:00:00:00:00
}
0 Done
1 Display the access list
2 Add member based on its Port/Node WWN
3 Delete member based on its Port/Node WWN
select : (0..3) [1] 0
done ...
Update the FLASH? (yes, y, no, n): [yes] y
*Successfully saved the MS ACL to the flash.
Deleting a member from the ACL
1. Connect to the switch and log in as admin.
2. Enter the msConfigure command.
The command becomes interactive.
3. At the select prompt, enter 3 to delete a member based on its port/node WWN.
4. At the Port/Node WWN prompt, enter the WWN of the member to be deleted from the ACL.
5. At the select prompt, enter 1 to display the access list so you can verify that the WWN you entered
was deleted from the ACL.
6. After verifying that the WWN was deleted correctly, enter 0 at the select prompt to end the session.
7. At the Update the FLASH? prompt, enter y.

HP A7533A - Brocade 4Gb SAN Switch Base Specifications

General

Brand	HP
Model	A7533A - Brocade 4Gb SAN Switch Base
Category	Switch
Language	English