HP A7533A - Brocade 4Gb SAN Switch Base - Mapping Luns on a Specific Port to an Iscsi VT

Fabric OS 6.2 administrator guide 317
-l <n:n> Maps the physical FC LUNs to virtual iSCSI LUNs and is specified as a pair:
LUNs:physical LUNs
The following is an example:
switch:admin> iscsicfg --add lun -t
iqn.2002-12.com.brocade:example-disk001 \
-w 21:00:00:04:cf:e7:73:7e -l 0:0
The operation completed successfully.
6. Enter the iscsiCfg
--show lun command with –t <IQN> options to verify that the LUN has been
added to the iSCSI VT, where -t is the IQN that identifies the iSCSI VT.
The following is an example.
switch:admin> iscsicfg --show lun -t
iqn.2002-12.com.brocade:example-disk001
Number of targets found: 1
Target: iqn.2006-10.com.example:disk001
Number of LUN Maps: 1
FC WWN Virtual LUN(s) Physical LUN(s)
21:00:00:04:cf:e7:73:7e 0 0
Mapping LUNs on a specific port to an iSCSI VT
1. Connect to the switch and log in.
2. Enter the iscsiCfg
--add lun command with –t <IQN>, –w <port_WWN>, and –l <n:n>
options to add LUNs attached to a specific port device to an iSCSI VT
where:
-t <IQN> Specifies the unique IQN name for the iSCSI VT in the format:
iqn.2002-12.com.brocade:<user_defined_name>.
-w <port_WWN> Specifies the port WWN of the physical FC target
-l <n:n> Maps the physical FC LUNs to virtual iSCSI LUNs and is specified as a pair:
LUNs:physical LUNs
The following example maps two LUNs attached to port 2f:ff:00:06:2b:0d:12:99 to an iSCSI VT
named iqn.2002-12.com.brocade:example-disk001.
switch:admin> iscsicfg --add lun -t
iqn.2002-12.com.brocade:example-disk001 \
-w 2f:ff:00:06:2b:0d:12:99 -l 1-2:0-1
The operation completed successfully.
switch:admin> iscsicfg --show lun -t
iqn.2002-12.com.brocade:example-disk001
Number of targets found: 1
Target: iqn.2002-12.com.brocade:example-disk001
Number of LUN Maps: 2
FC WWN Virtual LUN(s) Physical LUN(s)
21:00:00:04:cf:e7:73:7e 0 0
2f:ff:00:06:2b:0d:12:99 1-2 0-1